Connection of beam to the column using top and bottom flange plate under cyclic loading Abaqus

Connection of beam to the column using top and bottom flange plate under cyclic loading Abaqus

In this example , we intend to simulate the connection of beam to the column using top and bottom flange plate in the abaqus software

As you observe in this picture, the model is composed of beam , column , top flange plate , bottom flange plate , shear plate , continuity plate and weld

In this question , a cyclic loading is applied to the end of the beam and following that the hysteresis diagram of the model is drawn

In this picture, the hysteresis diagram gained from the Abaqus software has been compared with the experimental results

In these pictures, the deformation of the shear wall under the cyclic loading can be observed

This project has been validated, which means that the results obtained from Abaqus software are similar to the results of the article. In other words, this project is based on the article

Suggested package